The Tap Stand is pre-assembled and tested ready for easy installation. A typical new installation would be as follows. Excavate the ground to a suitable depth, place the template over the water pipe, making sure it is level then cover with concrete. Calculate the length of incoming water pipe needed to enter the connection at the bottom of the tap stand. Position tap stand over stud bolts and carefully lower the tap stand into position, making sure the water pipe is fully inserted into the connection. Fasten down the tap stand with the bolts provided.

Also incorporated is a foam insulation pack to provide additional tap insulation.
Please ensure that the correct backflow arrangements are adequate for your particular installation.

Each Kit comes complete with the following:-

TAP BOX
• 2 x 1/2" Hose Connectors
• 1 x 1/2" and 3/4" Tap Connector
• 1 x 1/2" 2 way Connector
• 1 x 260mm long 1/2" Hose
• 2 x rubber gromets
• 1 x insulation to place on wall
• 1 x Foam Insulation pack
• Complete with fittings & fixing instructions


TAP STAND
• 1 x 1/2" Bib Tap incorporating double check valve.
• 1 x Drain off Valve
• 1 x Stop Cock
• 1 x 20mm Water Connector
• 1 x Ground Fixing Template