Standpipe Installation

 

The standpipe requires minimum assembly with no special tools as per exploded diagram.  

Place the lower part of the standpipe over the incoming water pipe, then fasten to existing substrate. Calculate the length of incoming water pipe needed to enter the connection at the bottom of the standpipe and then position over the lower part that has been fastened to the ground and carefully lower the standpipe into position, making sure the water pipe is fully inserted into the connection. Fasten the standpipe together with the bolts provided.

Should you wish to stop unauthorised use the standpipe latches will accept your own padlock. (alternatively you may order an additional camlock to be fitted).

The drop down door on the front comes complete with a camlock and 2 keys as standard.

Also incorporated is Climaflex foam insulation to provide additional protection to the tap and associated pipework.

Please ensure that the correct backflow arrangements are adequate for your particular installation.

Each Kit comes complete with the following:-

Tap Box
  • 1 x 260mm long 1/2" Hose
  • 1 x 1/2" hose connector
  • 2 x Rubber Gromets
  • 1 x Foam Tap Cover
 Standpipe
  • 1 x 1/2" Bib Tap
  • 1 x BS6282 double check valve 
  • 1 x Drain Of Valve 
  • 1 x Stop Tap
  • 1 x 20mm Water Connector

PLEASE CLICK ON PRODUCT/PRICES AT THE TOP OF THE PAGE TO VIEW MORE INFO OR TO PLACE AN ORDER.

spipeabovenew17.jpg

spipeaboveexplnew.jpg


Should you require any further information on our Standpipe please contact us.
Trade enquiries welcome